pew222
8 Point Buck
Posts: 256
Likes: 0
Joined: May 14, 2024 23:34:22 GMT -5
|
Post by pew222 on Feb 17, 2007 16:37:43 GMT -5
I sighted my first pin in at 20 yds. How do I adjust the rest of the pins for various yardages?
|
|
|
|
Post by BackWoods on Feb 17, 2007 22:19:39 GMT -5
Pew22, If you are talking yardage some people like 15, 20, 30, 40 etc. or some like using 15, 25, 35, etc. I personally sight my set up at 20,30,40, but did have a bow that was able to use the first pin out to 30 yards.. So experiment alittle to see whats best for your setup..(poundage,grains of arrows ,etc. comes in to play) Hope this helps...
|
|
pew222
8 Point Buck
Posts: 256
Likes: 0
Joined: May 14, 2024 23:34:22 GMT -5
|
Post by pew222 on Feb 18, 2007 9:46:25 GMT -5
Im referring to moving the pins on the sight. It didnt come with any directions and I dont want to break it. I dont know how to raise and lower the pins to create the gaps for the different distances.
|
|
|
|
Post by BackWoods on Feb 18, 2007 10:43:47 GMT -5
I had that sight before ... Let me think.. Each pin is easily adjusted with a NO-Tools pin system, by unlocking the cam lock and then adjust each pin vertically with a gear tech lever. On the bottom of the sight on the right(I think) there should be a black tab(cam lock) for each pin to release each pin seperately.. and on the other side closer to the bottom of the sight there will be a tabs(cam locks) that move each pin seperalely by moving each tab up or down.. So find out which tab releasees the pin and then use the other tab on the other side of the sight to move the pin up or down.. It sounds hard but its not.. If u need more help dont hesitate to PM me.. Good luck Steve
|
|
